Category Archives: Field Reports

642 Miles Per Watt with the new Icom IC-705 QRP transceiver

Thursday, I set out to test how long the Icom IC-705 could operate during a Parks On The Air (POTA) activation with one fully-charged Icom BP-272 Li-ion battery pack. This, following my listening endurance test.

I knew conditions were pretty terrible Thursday in terms of propagation, but that didn’t really matter. I intended to call “CQ POTA” in CW until the ‘705 finally shut down due to low voltage. In my head, I imagined this wouldn’t take much longer than 1.5 to 2 hours and during that time, despite propagation, surely I’d work 10 stations to validate the activation, right–?

Sandy Mush Game Lands (K-6949)

I picked Sandy Mush Game Lands as my test site. Since I’d been there before, I knew there were ample trees to hang the Vibroplex EFT-MTR end-fed antenna, and I knew I’d likely be the only one in the parking area as this site is secluded and this was not a designated hunting day.

The Vibroplex/End-Fedz EFT-MTR antenna

Setup at the site was pretty straight-forward. I quickly deployed the EFT-MTR antenna–using my arborist throw line–in a “V” shape hanging over a high tree branch.

I picked the EFT-MTR because it’s resonant on my three favorite POTA bands: 40, 30, and 20 meters. Note that the IC-705 does not have an internal ATU.

Although I have an mAT-705 external ATU on loan to test, I didn’t take it to this first activation–I wanted to keep the set up simple for testing battery endurance.

On the Air

I started calling CQ at 16:30 UTC on the 40 meter band and set the IC-705 to beacon mode call “CQ POTA K4SWL.” No replies for 10 minutes. At that point, I discovered the POTA spots website was down for a scheduled upgrade (I have impeccable timing!), so I posted my spot on the POTA Facebook page.

Then my buddy Mike (K8RAT) sent a text message stating that the Reverse Beacon Network (RBN) had spotted me, but with a very low signal report. Hmmm….why would that be?

Turns out, I still had the IC-705 power level set to “0” watts (this story might sound familiar). Doh!

Note to IC-705 owners: zero watts is not zero watts!

I turned up the power to 5 watts (the max the IC-705 will achieve on a 7.4V battery pack) and was greeted by an instant CW pile-up.

What a blast! I started on 40 meters in CW, but eventually worked both 40 and 20 meters in SSB and CW. I then lowered the antenna, removed the SMA cap on the EFT-MTR coil, and worked 30 meters CW for the remainder of my time.

I logged my first contact at 16:28, my last at 18:18 UTC. So 1 hour 50 minutes of near constant operating.

Remaining battery capacity after 1:50 of operating.

The IC-705 battery pack was still going strong and had about 40% capacity left, but I simply ran out of time as I needed to run an errand in town, so had to shut down the radio and pack up.

I must admit: the IC-705 is doing a much better job managing battery usage than I would have expected. I’m guessing I could have operated for 3 hours or so at 5 watts without needing to recharge the BP-272 1880 mAh Li-ion battery pack.

I do believe I’ll invest in the larger BP-307 battery pack which has a capacity of 3100 mAh. It’s a pricey battery, though, at $130 US.

How does the IC-705’s battery endurance compare with the Elecraft KX2? I’m not sure yet, but I’m guessing the KX2 will have even better longevity as its current drain is less than half that of the IC-705. The KX2 will operate at 10 watts output for about 1 hour 15 minutes with the internal battery pack, before decreasing to 5 watts output. I’ve never tried a battery endurance test with the KX2 at only 5 watts.

Of course, with an external 12 volt battery, the IC-705 will pump out a full 10 watts of power as well.

Five watts and a wire–wow!

The biggest surprise of the day?

I worked stations from Oregon, and Saskatchewan to the Azores…in single sideband!

Here’s a map of my contacts–red signal paths are SSB, CW in green (click to enlarge):

This was one activation where 5 watts SSB actually snagged more DX than CW. Great fun!

While I’d like to think it was a little IC-705 “mojo” on its first field outing, in truth it had everything to do with the EFT-MTR antenna and what must have been a moment of propagation stability.

This was also my maiden voyage with the CW Morse Single Lever paddle. CW Morse sent this paddle, along with their double lever paddle and a selection of straight keys, for me to evaluate. If you’ve been considering an affordable, portable single-lever paddle, this is a brilliant one. I really enjoyed using it and the action is very easy to adjust.

I’m already regretting the decision to send it to my buddy Eric (WD8RIF) for a proper evaluation. (Just kidding, Eric! (Maybe.)) He only uses a single lever paddle for his numerous field radio adventures.

Eric will give this single-lever paddle a proper workout and give us a full report.

I must admit, I had a lot of fun with the IC-705/EFT-MTR antenna combo.

Of course, I’ll be taking the IC-705 to the field a lot in the coming weeks.

IC-705 Questions?

Feel free to comment and ask any questions you may have about the IC-705. I’ll do my best to answer them.

POTA Portable, Picnic, Paddles, and Unpredictable Propagation

Practicing left hand lunching, right hand keying/logging!

It seems like lately I’ve had to work hard to log 10-15 contacts during my Parks On The Air (POTA) activations.  Propagation has been so flaky, I use every trick in the book to snag at least my ten contacts for a valid activation: change antenna configuration, run up to 40-50 watts output, employ both CW and SSB, have friends spot me on the network, and try every band possible (typically from 80-17).

Note that the majority of my activations are proper QRP and rarely do I spend longer than 60 to 90 minutes actually on the air. Indeed, many of my activations are only 60 minutes long including set-up and take-down. That may seem short to most POTA folks, but that’s what works in my schedule and family life: quick hits. It’s one of the reasons I’m not more active in Summits On The Air (SOTA)–I need more time for those sites as they’re not as accessible as our numerous POTA entities.

Still, our local star has been misbehaving, and I had not planned to do an activation on Sunday (September 28) because I saw the propagation forecast and it was rather discouraging (A index 26, SW 505, Bz -2).

From home that morning, I chased a few parks but found it challenging to hear most of them. QSB was incredibly deep–strong stations gone in an instant.

Still, my wife suggested we take a picnic to one of our favorite local spots and how could I possibly visit a park without activating it? Right–?

Zebulon B. Vance Birthplace (K-6856)

What we, as a family, love about this site is the large covered picnic area and historic log cabins. Also, the site receives very few visitors on Sundays when the main museum is closed.

Each time we visit the Vance site, we bring my MSR liquid fuel stove and make lunch/dinner.

I set up the stove, got lunch started and my wife took over food prep.

Knowing propagation was unstable, I opted for more than QRP power this time–at least, at first–so I chose the Mission RGO One transceiver (capable of 55 W output) and CHA Emcomm III Portable antenna for this activation.

I deployed the Emcomm III in a sloping configuration with the end of the 73′ radiator high in a nearby (dead) tree and the counterpoise on the ground. I also suspended the winder/balun from the corner of one of the shelter’s rafter’s with paracord.

Since it’s difficult to see a wire antenna in photos, I’ve labeled the components in the following image (click to enlarge):

I didn’t know if this configuration would prove useful, but I knew it would be better than attempting this activation with my Wolf River Coils TIA vertical antenna.

I hopped on the air starting on 80M CW (at the request of my buddy WD8RIF), worked him and three stations in rapid succession. After a few minutes of silence, I moved up to the 40 meter band and worked 16 stations. I then moved to 30 meters and worked 11 stations.

I was working more stations than I would have ever guessed beforehand.

Since I only had about 10 minutes to spare after working 30 meters, I decided to plug in the microphone and work some park-to-park contacts. While I always intend to hunt for other parks while I’m in the field, more times than not, I don’t have the luxury of an Internet connection to check the POTA spots page like I did at Vance on Sunday.

I worked 5 parks: 3 in SSB and 2 in CW.

Speaking of CW, this was my first field activation using CW Morse Double Paddles.

CW Morse recently surprised me by sending a few of their products to evaluate in the field (guessing they saw my previous post asking about keys–?).

I must say, I really love the CW Morse double paddles. They’re fully (and easily) adjustable, the action is responsive and smooth, and with the base, they’re incredibly stable on a hard surface. I highly recommend them.

At a setting like we had at Vance, I love the heavy base plate, but if I planned to hike into a site, I believe I’d remove the base to save on weight.

Unpredictable Propagation?

Perhaps there was a brief window of stability between solar events and I was able to take advantage of that while I was on the air? I’m not sure.

I never expected to log 37 contacts in the space of a little over an hour (with some of that time being off the air to help with picnic prep). Not on that Sunday when the solar numbers were in the dumps.

I’d like to believe it was a combination of things:

  • A large wire field antenna with decent gain and the ability to work multiple bands
  • 40 watts of power (at first, I backed down to QRP on 30 meters)
  • Using CW for 34 of the 37 contacts
  • Perhaps unintentionally good timing

All I know is, I had a blast! It’s hard to beat a combination of good radio, good food, good scenery, and good weather!

I suppose this was also a lesson in simply hitting the field and ignoring the propagation.

Or as Rear Admiral David G. Farragut once famously said, “Damn the torpedoes, full speed ahead!”