Tag Archives: Peter (K1PCN)

Field Reports, Guest Posts, News, Portable, POTA, QRP, SOTA

SOTA, POTA, and a Total Solar Eclipse Adventure: Conrad and Peter Pack It In!

7 Comments

Many thanks to Conrad (N2YCH) who shares the following field report:

QRP POTA & SOTA on Killington Peak, Vermont

By Conrad Trautmann (N2YCH)

Peter (K1PCN) and I decided to travel from Connecticut to Vermont to view the solar eclipse that occurred on April 8, 2024.

We got an early start on Sunday morning April 7th to drive to Rutland, Vermont where we stayed overnight. This positioned us well for a short drive the next morning to drive North towards Burlington, where we’d be under the path of totality.

Knowing we’d have some extra time on our hands on Sunday afternoon, Peter planned two park activations. Our first stop was Calvin Coolidge State Park (POTA US-5541 & SOTA W1/GM-002), which encompasses Killington Peak and is also a two-fer with the Appalachian Trail (US-4556). We also activated Gifford Woods State Park (US-3115), which isn’t too far from Killington.

For the trip up the mountain, we “walked-on” the K1 Gondola ski lift to get up most of the way.

From the top of the ski lift, we hiked another 360 feet, up 100 feet in elevation, in the snow, to get to the actual summit at approximately 4,230’ above sea level.

Photo of Peter and me on the summit

Our kits needed to be self-contained and not too heavy for the hike. Peter packed his Icom IC-705 along with a fiberglass mast and an end-fed half wave wire antenna to do a sideband activation. I brought my Elecraft KX-3, 3Ah Bioenno LifPo battery, and the Elecraft AX-1 antenna to do a digital activation. We both activated on 20 meters and were far enough apart that we didn’t interfere with one another. We also tried 17 meters.

Conrad, N2YCH’s equipment list

Peter, K1PCN’s Equipment List

After the hike up, we surveyed the area to see where the best spots would be for us to set up. Peter took one side of the summit while I set up on an exposed rock so I wouldn’t be sitting in the snow. Peter wore his ski pants…I, on the other hand, ended up with wet jeans by the end. I’ll re-think my attire the next time I do this. I got the radio equipment right but not the clothing selection. Priorities!

Conrad, N2YCH on the summit of Killington Peak in Vermont
Peter, K1PCN with EFHW antenna, which you can see if you look very closely
Peter, K1PCN and his radio and antenna

In addition to the HF radios, we both brought our VHF/UHF handhelds to make contact with each other as well as anyone who might be nearby. Peter brought a Baofeng UV-5R and I brought a Kenwood TH-D72. I was lucky enough to complete a QSO with someone who was mobile and driving along US Route 89, which at its closest point to Killington Peak is a solid 20 miles away. I verified that via email with the other ham after the fact. Continue reading SOTA, POTA, and a Total Solar Eclipse Adventure: Conrad and Peter Pack It In! →

Digital Modes, Field Reports, FT8, News, Portable, POTA, QRP, SSB

Part 3: N2YCH and K1PCN’s Dayton Hamvention Trip QRP POTA Rove

2 Comments

Many thanks to Conrad (N2YCH) who shares the first of a three-part field report series outlining his 2023 Hamvention rove with Peter (K1PCN). Click here for Part 1 and Part 2.

Part 3: Dayton Hamvention Trip QRP POTA Rove

By Conrad Trautmann, N2YCH

The Bonus State

Welcome to part three of a three-part POTA rove story where Peter, K1PCN and I decided to activate six state parks for our Parks on the Air Activated States Award on the drive to the Dayton Hamvention.

In installments one and two we activated Delaware, Maryland, West Virgina, Pennsylvania, Ohio and Indiana. I thought we had exhausted all our state activating possibilities for this trip, until…Peter said, “you know, Kentucky is not that far away. And, by the way, there is a park down there that has never been activated digitally…”

Really? I’m in.

We decided that on day two of the Hamvention, we would leave in the afternoon and make our way to Kentucky, which was just over an hour away. While we were standing on the line to get into the Hamvention on Saturday morning, one of the people near us mentioned that the Voice of America Museum was open until 9pm that night and he was considering going.

I stopped at the VOA booth in the Hamvention and picked up a brochure and on our way to Kentucky, Peter suggested that maybe on the way back, we stop in.

Kentucky

Our best bet for a Kentucky POTA activation, which was recommended by a fellow digital activator at the South West Ohio DX association dinner we attended the night before, was Big Bone Lick State Historic Site (K-3779).  According to the Internet, it was named Big Bone Lick because of the “mammoth artifacts that were found and because of the salt springs that animals drank.” I found that it was impossible to tell anyone the name of the park without a smirk or chuckle in return.

When we arrived in Kentucky, we drove around Big Bone Lick park looking for a place to activate. Apparently, there are buffalo at the park…however, we did not activate near the buffalo. We found an unused picnic area and split up.

Literally about five minutes after I set up and got on the air, a group of moms with five-year-olds celebrating one of their birthday’s showed up. One of the mom’s apologized and explained that I had found her secret place in the park…but by then, I had almost completed my activation and was ready to break down.

I don’t mind it when people come up and ask about what I am doing, I’m always happy to explain ham radio to anyone who’s curious. Activating a park surrounded by a group of five-year-olds was a new experience that I hope to never repeat. Here is a photo of my setup at Big Bone Lick.

Given that it was later in the day by the time we arrived, Peter chose 40 meters, and I took 20 meters. 22 QSO’s later, here’s my coverage using the Buddipole with the 17’ MFJ whip and the Elecraft KX3 at 10 watts.

VOA

On our way back, Peter called the VOA museum to confirm they would be open late that night and then that became our next destination since we had to pass right by on our way back to Dayton. Continue reading Part 3: N2YCH and K1PCN’s Dayton Hamvention Trip QRP POTA Rove →

Articles, Digital Modes, Field Reports, FT8, News, Portable, POTA, QRP, SSB

Part 2: N2YCH and K1PCN’s Dayton Hamvention Trip QRP POTA Rove

4 Comments

Many thanks to Conrad (N2YCH) who shares the first of a three-part field report series outlining his 2023 Hamvention rove with Peter (K1PCN). Click here for Part 1, and look for Part 3 next week!

Part 2: Dayton Hamvention Trip QRP POTA Rove

By Conrad Trautmann, N2YCH

Pennsylvania

Welcome to part two of three of the Hamvention QRP POTA Rove. If you missed part one, you can find that installment here.

Early on Thursday morning, May 18, 2023, Peter, K1PCN and I headed from Morgantown, West Virginia north to Pennsylvania to activate K-8920, the PA 223, Pennsylvania State Game Lands. While the park covered a large geographical area, we were able to find a parking lot not far off the highway that made it easy for us to get to and activate.

Peter spotted a nearby gazebo which was also a viewing area and hiked over to it to activate. If you look closely in the photo below, you can see it in the distance behind the sign and my antenna.  I stayed with the Jeep and set up on the tailgate using the Buddipole vertical.

Since it was early in the day, we used our frequency strategy of Peter on 40 meters and me on 20 meters. My QSO map here shows some decent DX for QRP on 20 meters at 8am ET.

Ohio

We traveled North towards Pittsburgh on Interstate 79 and then West on Interstate 70, passing through West Virginia again and then stopped at K-1934, Barkcamp State Park in Ohio.

I tuned my antenna for 17 meters and Peter activated on 20 meters.

I managed to activate the park, but it was slow going for me on 17, so when Peter finished up on 20, I changed to 20 meters and got a few more on that band just for good measure. Thinking that the slow QSO’s could have been the radio, I did switch to the IC-705 here, but that did not make any difference. It could have been conditions or our location. I did have better luck on 20 meters than 17. And I don’t know about you, but I can never go for just ten QSO’s. I feel like I need a few extra ones just in case. Here is a photo of me set up at a picnic table next to my antenna. Continue reading Part 2: N2YCH and K1PCN’s Dayton Hamvention Trip QRP POTA Rove →

Digital Modes, Field Reports, FT8, Hams, News, Portable, POTA, SSB

Part 1: N2YCH and K1PCN’s Dayton Hamvention Trip QRP POTA Rove

3 Comments

Many thanks to Conrad (N2YCH) who shares the first of a three-part field report series outlining his 2023 Hamvention rove with Peter (K1PCN). Look for Part 2 next week!

Part 1: Dayton Hamvention Trip QRP POTA Rove

By Conrad Trautmann, N2YCH

Peter, K1PCN and I are both avid Parks On The Air activators here in Connecticut and neither of us has ever been to the Dayton Hamvention in Xenia, Ohio. At the urging of others who have attended in the past, we made the decision to attend this year and while we were making the trek out, we wanted to activate parks along the way to add to our activated US states award. We originally planned to activate six states and ended up with one bonus state for a total of seven. This is how things looked before and after the trip.

 

I would like to begin by saying that attending the Hamvention was a great experience. If you have not been to it, I would like to encourage you to attend if you can.

You may have heard about the flea market, the vendor booths, the forum sessions or the food trucks, which are all good, but the best part for me was being in the presence of other hams with similar interests. I struck up conversations and shared stories with many other hams. Everyone was very nice and willing to share their experiences, which is a great way to pick up some good tips.

I am extremely glad I went. If you are on the fence about going, I would recommend you plan to go next year. Oh, and I got to meet this guy in person….

Now on to the rove…

I planned the trip to get as many states as possible. Both Peter and I had already activated CT, NY and NJ, so we did not need to stop in those states as we passed through. I had scoped out some parks near the Delaware and Maryland border, so I looked at those first.

My main criteria on park selection was to pick parks that would be easy-off/easy-on to the main highways we would be traveling to save time on driving. Here is the route map we followed.

We strategized on how we would activate the parks when we got to each one. Peter is an SSB activator, and I am a digital activator. We would not be colliding on the mode of operation. We did need to be on different frequencies though.

In the mornings, Peter took 40 meters and I used 20 meters. Later in the day when the bands opened up, Peter moved up to 20 meters and I bumped up to 17 or 15 meters. Using this strategy, we had no problems getting our minimum ten QSO’s to activate while operating at the same time. Peter also reminded me to bring a handheld and we did park to park QSO’s on 2 meters and 70cm.

As for equipment, I used my Elecraft KX3 transceiver, but I did bring an IC-705 as a backup.

On the first stop in Delaware, I used an Elecraft AX1 antenna but for the rest of the trip I used a Buddipole tripod equipped with a Versa-T with a 17’ MFJ whip tuned to the frequency I was operating on with 50’ cable and an above the ground counterpoise. Continue reading Part 1: N2YCH and K1PCN’s Dayton Hamvention Trip QRP POTA Rove →