Joe (KD2QBK) | Q R P e r

Many thanks to Joe (KD2QBK) who writes:

Hi Thomas:

I’ve recently discovered QRP FT8, which I’ve been working with my Icom IC-705. I run with an end-fed sloper that runs out of my 2nd floor shack window using a 49:1 unun and a length of RG-58. I’m also using an Emtech ZM-2 tuner between the antenna and the radio when needed.

The set up works really nicely, except for the way FT8 heats up and overtaxes the radio after a while. Searching around a bit, I’ve found just the right solution for that issue. The AC Infinity MULTIFAN S1 USB-powered table fan.

https://amzn.to/3DvqemJ (affiliate link)

It’s basically just a 3-inch square fan like you’d find in a computer or some other electronic devices, with rubber “feet” attached. It can stand upright or lay flat depending on your need. it’s stated purpose is to cool or ventilate routers, game consoles, audio equipment, etc.

The AC Infinity MULTIFAN S1 includes a speed control switch and an inline USB socket to daisy-chain other devices. One caveat with the inline socket: because it’s placed in the line between the fan and the speed control switch, the switch must be set to high speed else the socket won’t have adequate power for the attached device.

All I do is plug the fan into a USB socket and place it at the rear of the radio, sans battery, to keep it cool. I have it set up to blow onto the radio. Obviously I need to power the radio with an external source when the battery isn’t attached. I’ve not tried to use the fan with the battery attached, but I don’t think it would help much. The ventilation slots next to the battery compartment don’t seem wide enough to let much air in. Continue reading How Joe keeps his Icom IC-705 cool during long FT8 sessions →

Many thanks to Joe (KD2QBK) who writes:

Hi Thomas:

Like many I’ve taken the plunge on an Icom IC-705. Even though I sold off an old Yaesu 817 to finance part of it, it still cost a very pretty penny and I didn’t want to shell out more for a tilt stand or bail.

Especially at the rather extravagant prices they’re going for now. $30, $40? No thank you. (Really, the radio, at $1300, should have come with one in the box, but why beat that dead horse – it is what it is.)

In any case, I looked around the house for something to DIY one with. I found a couple of metal angle brackets, screws that fit the mounting holes, and some tiny rubber bumpers to shield from nicking up the radio’s plastic case. Voila! Instant tilt stand. See pics:

And just the right angle too. My plan is to plastic-dip the brackets so I can get rid of the bumpers as well as not nick up any softer surface the radio sits on.

IC-705 Bluetooth Question

Meanwhile, a question for you and other owners of this radio.

What’s up with the Bluetooth function? I have three bluetooth speakers and a small audio amp with built in BT, and I can’t get audio to play through them. The unit sees the accessories and connects. But no sound. I’d updated the firmware to 1.24, just in case they might have addressed any issue. Still no joy.

That being said, I can control the radio via BT with android apps, etc, but no audio. A very disappointing development for such an expensive radio.

Oh well. The good with the bad and all that…

Joe Patti (KD2QBK)

Thank you for sharing this, Joe! That’s a very clever and simple solution for the IC-705 stand.

As for the Bluetooth functionality, I’ve yet to use it. Hopefully, someone here can chime in and comment with advice!