As soon as we drove up to the activation site I had researched in advance, I surveyed the picnic area and mentally noted the best spot to deploy an end-fed half-wave using my trusty arborist throw line.
With the throw line’s assistance, I had an antenna deployed within a couple of minutes max.
It hit me then just how invaluable a tool the arborist throw line has become for the types of park and summit activations I do.
Pre-Throw Line Activations
During NPOTA (National Parks On The Air) in 2016, I wasn’t aware of arborist throw lines and had been using some high test monofilament fishing line attached to a weight.
The fishing line was strong enough to support my QRP antennas and I could typically reuse the same length of line for 2-3 activations. Eventually, the line stretches and weakens thus it must be cut off and discarded.
Never again
I’m a big Leave No Trace kind of guy, so am embarrassed to admit that during one activation, my fishing line snagged high up in a tree and left a bundle of broken monofilament in a spot where I could not retrieve it. This was deep in a forest and although I doubt anyone will ever see it, I know it’s there. It bugs me to this day and if I ever sort out a way to remove it, I certainly will.
I was searching for a more SOTA-friendly/backpack-able solution than the arborist throw line cube.
I was very skeptical about how easily this bag would work in the field. One of the reasons my throw line storage cube works so well is because the opening is large allowing the line to deploy without tangling. Packing up is fast because the line can be flaked back into the cube in a matter of seconds. Continue reading The arborist throw line is an invaluable field radio kit tool→
Since last year, I’ve become a bit of an arborist throw line evangelist. Arborist throw lines have made my wire antenna deployments so quick and easy compared with using monofilament fishing line or more complicated systems.
Since purchasing this arborist throw line last year, I’ve never looked back. The throw line never gets caught in tree branches, it’s reusable hundreds of times, and with it I can easily snag branches 50’+ above the ground to hang my wire antennas.
If I’m being honest, I was very skeptical about how easily this bag would work in the field. One of the reasons my throw line storage cube works so well is the opening is large allowing the line to deploy without tangling. Packing up is so fast because the line can be flaked back into the cube in a matter of seconds.
Before purchasing, I was afraid the compact throw line bag might get tangled when being stored in such a small stuff sack. I was really concerned packing the line in the storage bag might take too much time.
I purchased the the throw line bag and a new throw line from Weaver.
At home, I did a full break-in of the new throw line (attaching it to a tree, stretching it to full length, then pulling it for enough tension that some of the bend “memory” is removed). Then I attempted to simply stuff the line in my throw bag–it took ages, because the whole idea of a throw line is that it doesn’t easily tangle. The line wanted to “spring” from the bag as I tried stuffing it in.
A much better way: The “Figure 8” stuffing method
After a field activation this spring, I received a game-changing tip from one of my subscribers and I hope they step up to take credit! (Update: it was NW3S!–thank you!).
When stuffing the line back in the bag, wind it on your hand using the figure 8 method. I wind almost all of my lighter-weight cables and antenna wires in a figure 8 so that they deploy without getting tangled. I’ve been doing this for years and it works brilliantly.
I’d never thought about using this method on the arborist throw line. I was amazed with how effectively it worked.
Video demo
I made a short video (thank you for requesting this, Scott!) to better demonstrate how I pack my throw line storage bag now:
This method works amazingly well and I can usually pack the entire line within one or two minutes.
Again, I’m incredibly grateful to the subscriber who first suggested this method!
At least 95% of the time I’m playing radio in the field, I use wire antennas and suspend them in trees.
Since I do a lot of park activations for the POTA program, trees are typically very easy to come by and most of the time the park office doesn’t care if I hang an antenna in their tree for a couple of hours.
For years, I’ve been using a heavy steel nut–a nut that would fit a very large bolt–as a weight and attach it to fishing line. I then simply throw the nut into a tree and pray the fishing line deploys properly. I have reasonably good aim, so–on a good day–I typically only need one or two throws/tries to get the fishing line over a branch. On bad days? Well… let’s just not talk about that.
There are some inherent weaknesses in the fishing line/monofilament system:
First of all, I’m lobbing a heavy metal object into the trees. If it ricochets–and it eventually will–it can come back down to earth and land where you might not want it to (for example, on your radio, on your car, or on your friend’s head). Fortunately, I’ve never hit anything or anyone as I’m careful to clear the area first, but unfortunately, I once had the nut hit a tree and come back down near me. That was a little scary.
Secondly, fishing line isn’t exactly recyclable and you simply can’t use it over and over. I get at most three deployments with a section of fishing line before it gets too stretched and unworkable.
Finally, fishing line is incredibly prone to tangle, especially near the end of the spool.
A Better Solution? The Arborist’s Throw Line
The arborist throw line is no recent innovation. For years, I’ve read recommendations from other ham radio operators who swear by arborist throw lines but I only recently decided to take the plunge after one very frustrating park activation where my fishing line knotted and almost got permanently stuck in a gorgeous tree. I’m very much a “Leave No Trace” kind of guy, so I was incredibly relieved when I was finally able to work the fishing line out of the tree.
I once talked with an arborist about throw lines and he stressed the importance of getting not just the line, but also a throw line storage cube. The cube allows you to both deploy and take up the line without any tangles or knots.
All in, I spent about $50.00 US for both.
Preparing the throw line
My arborist buddy gave me an important tip: the throw line needs to be stretched.
As you can see in the photo above, the throw line is packed in a bundle that’s easy to unroll. After you unroll it for the first time, though, the line has a “memory” of all those bends from its life in the package.
You can remove much of the throw line memory by tying one end of the line to a tree and stretching the line to its full length. The line is 150 (or so) feet long, so you’ll need an open space to do this.
The arborist in this video shows how this is done (I’ve queued it to the point in the video where he shows how to do this):
Knots
You’ll need to attach the throw line to the throw weight, of course.
There are a number of knots arborists use, but I’m a fan of the slipped simple noose knot. Perhaps it’s because it’s easy to tie even with semi-rigid line, it holds quite well and, most importantly, it’s easy to untie.
Looks like arborists use it too because when searching for an instructional video, the first result was from an arborists’ channel:
Throwing up!
There are a few different ways to launch a throw line into a tree.
Take my advice here: practice at home before you hit the field! It could save you a lot of embarrassment, although, admittedly, my at-home practice sessions gave my wife and my daughters good reasons to chuckle.
I’ve only been using the throw line for a little over a week, so I’m still sorting out which method works best for me. One thing I discovered very quickly, though: no matter which launch method I use, I can send that throw weight into a tree at least 60% higher than I could before.
No doubt, the throw line and weight really put the laws of physics in your favor!
Here’s a great video highlighting different throw line launch techniques:
In practice
I took the throw line to the field today for the first time and I’m very pleased with how effectively it works.
I was able to place my antenna on a much higher branch than I could have otherwise. It took me three tries today, but it had more to do with my poor aim. As with any skill, this will, I think, improve with practice.
The storage cube folds down flat and keeps the line from tangling
Besides the improved antenna height, I love that the line can be used over and over again. Also, it’s strong enough that should it ever get caught in a tree, I can pull it out without the line breaking.
I can also reel in the line at least three or four times faster than I could with fishing line. Simply flake it into the storage cube one foot at a time.
When the line has been stored along with the throw weight, you can fold the storage cube down flat, then fold and secure it into a compact triangle.
Are there any negatives with the throw line system? Here are a few I’d note:
Bulk. Even when packed down, the line in the storage cube take up much more space than fishing line. Although it easily fits in even my smallest backpack (the GoRuck Bullet), I’m not sure I’d take it on a long hike.
This system requires a little practice and skill–you can’t pull it out of the package for the first time in the field and expect perfect line launches.
The throw line is more conspicuous than fishing line. If you’re trying to be a bit stealthy–as many of us are these days during the Covid-19 pandemic–the bright yellow throw line will attract more attention and questions from other hikers/campers, etc.
One happy activator!
Even though it’s bulky by my standards, I see the throw line becoming a permanent part of my field kit and I expect I’ll use it on most of my POTA activations.
Have you been using a throw line to hang field antennas? Or do you use a different system? Please comment!
QRP radios, product announcements, reviews, news and more. Low power amateur radio fun!
Please support QRPer by adding us to your whitelist in your ad blocker. Ads are what helps us stay online. All of our ads are ham radio related--no junk, we promise! Thank you!
During NPOTA (National Parks On The Air) in 2016, I wasn’t aware of arborist throw lines and had been using some high test monofilament fishing line attached to a weight.
