Scott’s Icom IC-705 manpack built on a Condor MCR3 chest plate

Many thanks to Scott (KA9P) who writes:

Here’s a MOLLE-related [piece of field kit] you may not have seen yet.

My summer 2022 QRP /PM rig is built around a Condor chest plate – not really a pack although there is a plate carrier compartment that thinner things store in easily enough. And I often have a small accessory pouch in the chest plate.

The key ingredient is the IC-705 adapter plate, made from scrap 0.06 inch thick aluminum scrap.

The four tines that fit the chest plate MOLLE webbing are spaced per the MOOLE/PALS standard of every 1 1/2 inches, but the tines themselves are 3/4 inch wide rather than 1 inch to make them easier to insert in the chest plate.

 

The plate is attached to the 705 with M4 by 10 socket head screws. I first used a single quick disconnect 1/4-20 photographer’s knob, and it worked, but eventually would loosen enough that the radio would start to swivel.

The orange strap that retains the adapter plate at the top of the chest plate is riveted to the adapter plate with plastic POM rivets. The chest plate is a Condor MCR3, about 26 bucks on eBay.

The radio goes in and out of the chest plate in less than a minute, and the adapter plate can be removed in a minute or two. The radio is very stable and easy to operate.

As a bonus, the loops also hold a Buddistick mast section, then a Versatee with a Buddistick.

With the antenna in front, I can change bands and adjust the whip and coil while standing. The antenna also goes in and out of the chest plate quickly.

I’m finding it’s great fun to listen and operate on the way to and from my operating destination. Definitely the easiest /PM set I’ve had. Every control and jack, and the battery, is easily accessed with the radio attached to the plate.

It’s like the 705 was intended to be used this way!

72, keep up the great work.

Scott ka9p

Absolutely fantastic pedestrian mobile setup, Scott! I love how the custom IC-705 mounting plate makes such a stable surface for the IC-705 to be suspended as you operate. As you say, you also have very easy access to all of the station components.  Brilliant!

Thank you for sharing your design notes and photos!

7 thoughts on “Scott’s Icom IC-705 manpack built on a Condor MCR3 chest plate”

      1. The 14 foot drag wire plugs in the blue banana jack on the VersaTee – so that it can go on easily. And pull out if it catches? Scott

  1. What a clever idea, I like it. It’s great for POTA, SOTA, or just a stroll around the trails. Thanks for sharing, 72 Ed WD8JVV

  2. Saw similar at Dayton HamVentions about 10 or more years ago, not a IC705, but I think FT817 with 500W amp, guy walking around transmitting with vertical.

    73, ron, n9ee/r

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.