This meter sounds like a fun and useful project. Purchase one here–all proceeds benefit OzarkCon! Details below:
(Source: Terry, WAØITP with The Four State QRP Group, via QRP-L)
The Four State QRP Group is pleased to announce a new kit, the QRPometer, a sensitive and accurate power/swr meter designed by David Cripe, NMØS. Complete specifications, assembly manual, and ordering information can be found here ttp://www.wa0itp.com/qrpom.html
PayPal is accepted.
The range of accurate power easurement extends down to a low 100 milliwatts. This kit was conceived to fill a need within the hobby for an inexpensive, highly accurate RF power and VSWR meter for QRP power levels. With it’s large digital display it makes a very useful addition to your shack.
The QRPometer uses simple analog signal-processing circuitry to provide a set of essential measurement features not previously available in a single unit. High quality, double sided,
printed circuit board construction is used, with solder mask and silk screened component reference designators.
All components are through-hole for easy assembly. NO toroids are required, and all controls and jacks are PCB mounted. The QRPometer can be constructed by beginners as well as experienced builders. Construction time is approximately 3 hours, depending on experience level. The only equipment required for calibration is a digital voltmeter, and a QRP transmitter..
All proceeds go to fund OzarkCon. As always, thank you for supporting the Four State QRP Group. http://www.4sqrp.com/
UPDATE: See comments–first run of these kits sold out within 27 hours! More to come later.