Many thanks to Mark Hirst who writes:
I got a new FT-891 recently and wanted a protective case for taking it out into the field.
A mixture of internet searches and Amazon algorithms turned up this very affordable case which closely matches the size of the radio, as the enclosed photograph shows.
It uses the familiar pick and pluck foam, although in two layers.
The base layer is a bit thin, so I might put a layer of rigid plastic over it to stop the feet of the radio pushing down to the outer case.
I prioritised the side wall thickness opposite from the carry handle, as the case is designed to sit on its side like a briefcase.
Wow, Mark! I do love the size of this case and the fact that it fits the FT-891 so perfectly.
Recently, I’ve been thinking about building out a case to hold one of my smaller QRP transceivers (the KX1, KX2, or MTR3B) in the field to be used when it’s raining. Perhaps this has been on my mind because I’ve been enjoying nearly 5 straight days of rain and fog! A case like this would be an affordable solution and I wouldn’t feel terribly bad about drilling through the case to mount antenna, key, mic, and headphone ports.
Thank you again for the tip!
Note that the Amazon affiliate links above support the QRPer at no cost to you. If you’d rather not use these links, simply search Amazon for “Max MAX004S.” Thank you!
2 thoughts on “Mark discovers an affordable IP67 rated protective case for the Yaesu FT-891”
Note that Yaesu just release new firmware for the FT-891. I’ll update mine as soon as we reach 32 degrees, lol.
Thank you, Frank!