Bob Tests the (tr)uSDX at Low Voltage

Many thanks to Bob (K7ZB), who shares the following guest post:


Experimenting with Low Voltage on the (tr)uSDX

by Bob (K7ZB)

I wanted to see how the (tr)uSDX would perform at lower voltages, so I decided to power it with a 6V Eveready lantern battery. With this setup, the radio delivered 1.1W to the antenna through an ATU-10, connected via 20 feet of RG-316 coax to a 20M Hamstick mounted off my condo balcony. I also used a wire counterpoise to complete the system.

Initially, I had planned to use a variable buck converter to step down the voltage from my 12V battery packs incrementally while measuring output power.

DROK DC Buck Module, Adjustable Buck Converter Step Down Voltage Regulator 6V-32V 30V 24V 12V to 1.5-32V 5V 5A

Unfortunately, the buck converter couldn’t handle the radio’s load and tripped offline each time I tried to use it. While it wasn’t suitable for this experiment, it’s still a handy and flexible little converter for other purposes.

Testing with the Lantern Battery

Switching to the 6V lantern battery, I used an antenna analyzer to fine-tune the counterpoise length, geometry, and placement. I achieved an acceptable SWR just under 3:1 at the radio end of the coax, which the ATU-10 easily matched down to 1:1.

Transmit performance was promising—I received a 10dB RBN report from AC0C in Kansas City at sunrise, running 1.1W. I also monitored my own signal using an ATS-20 receiver inside the condo.

The Receive Issue at 6V

However, reception was a different story. While the transmit side worked well, the receiver performance was significantly degraded. At 6V, my Malahit (tr)uSDX, which is normally a solid receiver at 12V, struggled to pick up signals. The noise level was noticeably high, and I could barely hear anything. I’m curious if others have experienced similar issues when running this radio at lower voltages.

Success at 12V

3-D printed hamstick AZ-EL adaptor design by AB7E

To compare, I switched to a Talentcell 12V 3000mAh Lithium-ion battery pack, and the radio instantly performed as expected. With 5W output, I quickly made a QSO with a station in Vermont—a night-and-day difference from the 6V test!

What a delightful little QRP rig this is!

73, de K7ZB
Bob
Gilbert, AZ

9 thoughts on “Bob Tests the (tr)uSDX at Low Voltage”

  1. Hi Bob,
    I often feed the little wonder with 5v USB, and I have never noticed a degradation of the characteristics in reception, I don’t understand why it should. By the way, you used 6 volts. I’ll do some tests and get back to you here.
    73 IW2EPE Luca

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.